TBK-508 is a 2017 hot LCD repair machine OCA vacuum laminating machine vacuum defoaming machine and auto repair tool.
The latest OCA vacuum lamination machine , can be suitable for touch screen cover plate (cover lens) and functional glass sensor of OCA laminating process.
Apply to the touch screen (touch panel) and liquid crystal module (LCD panel) of the OCA laminating process, at the same time can also be applied to other areas of membrane, glass to glass (glass) of hard in hard OCA laminating process.
1.New upgrade 5 in 1 vacuum laminating machine with touch system, a key to start, easy to operate.
Adopt advanced constant temperature, constant pressure technology, 100% vacuum effect , no bubbles at all.
2.Laminating dont need moulds,only need use Bakelite mould Alignment screen before put it to the machine,Save cost. Using the most advanced pressure principle, have the best laminating effect.
3.Built-in Customize oiless vacuum pump, ultra-quiet, long service life.
Machine only have 48KG, passed CE certification,suitable for Europe and USA Market ,very convenient.
4.Super practical intelligent 5 in 1 laminating machine ,Touch system,Multi-functions.
Built-in bubble remove machine/air compressor/vacuum pump.
And this machine has 2 working models:
Model 1: Set the laminating time 3 minutes
In this model, mostly there is no any air bubble if you install the OCA film on the LCD very well before laminating. so there is no need to use the autoclave for air bubble removing after laminating finished.
Model 2: Set the laminating time 30 seconds only (this model is good for those workshop which need fast refurbishing )
In this model, it will only take 30 seconds to finish the laminating, the refurbishing efficiency is about 120pcs/hour, but it needed the autoclave to remove the air bubbles after laminating finished.
Post time: 12-27-2017